The hassle: i have a desk saw motor i am seeking to use in a jointer and want it to spin inside the opposite course (completely). I have had trouble finding an answer that i am fairly sure applies. Most of the solutions i have observed concerning this seem to be for extra complicated or special types of motors (or very vague on what kind of motor is being discussed). The closest answer i have found is that this one: reversing route of a 115v ac motor using arduino. Preferred final results: in an effort to spin at 5000 rpm in the opposite path so i'm able to strength a separate shaft (jointer cutter head) connected via a belt/pulley in a 1:2 ratio for a total output of 10,000 rpm.
The hyperlink which you offer and the comment via john d say what ought to be achieved. The armature and field connections need to be reversed with recognize to each other. In the diagram, you disconnect the black lead and the red lead from the two brushes and reconnect every to the alternative brush. I would love the opinion of someone greater professional and knowledgable than myself on if it's miles feasible and secure to opposite this motor. A number of the opposite answers i have discovered eluded to the motor now not being secure to run or running at extensively reduced power. Alternatively, if there are a few tests that i ought to run to evaluate these for myself, any information on what assessments and a way to conduct them would be much liked.