IoT security camera - Hackster.io - Usb wiring diagram electricity picture inside usb wiring diagram is one from many photograph from this internet site. You can find the modern day images of usb wiring diagram power photograph inside usb wiring diagram on this website and different pics. We are hoping this image can be useful for you. You'll note that there are black wires soldered to the cable defend. One is for the metallic protect for the microphone: you can cut it away. A 2d one is hooked up to the board at the pin marked c in this photograph. Apparently, it is not wanted via the webcam, so i simply unsoldered that (you can just reduce it away if you decide upon). Please be aware: this is my first mission publishing and i hopefully wrote enough element. Also, it's miles the primary shipping and i'm able to later update it with a few access control details and iot integration steps. Please read it as soon as before starting so you are privy to the small troubles and workarounds that i've located. Ever due to the fact that i have cut the wires so brief in the case, i took a longer piece of shielded cable from the unique usb cable and changed the wires at the board one at a time, soldering them to the corresponding pinout. Be patient and use a small soldering tip right here. The board is primarily based on a arm nine (atmel at91sam9g25) at 400 mhz with 256mb of ram and microsd for the os (see picture underneath). You could upload a wifi module simply on pinnacle to feature network connectivity. ?it runs debian linux and has a good quantity of i/o ports.
You may see that the usb cable is locked likely with glue to the center of the returned. In case you achieve unlocking it from the case you can try and pull some extra cable (10 cm) from the case before cutting it. Ever considering i was now not capable of release the cable i determined to clearly cut it at the extent of the case simply to extract the sensor. I then soldered the cable returned to the proper board pins. The board will appear like this:. You begin by means of unscrewing the 2 small screws on the lower back of the camera to get rid of the the front side. It has a small plastic clip however it will come away easily with the assist of a small screwdriver.